Smaart Loopback

Prev Next

Enabling Smaart Loopback allows any enabled output channel to also appear as a selectable input during measurement engine creation. This allows any device to act as the generator, creating a stable relationship in time between Smaart's generator loopback and your input device.


To Use Smaart Loopback:

  1. Open I-O Config either by navigating to Config > I-O Config or by using the [Alt/Option] + [A] hot key.

  2. Select any desired input and output device(s) and channel(s).

  3. Click the checkbox labeled “Enable Smaart Loopback” to check it.

  1. You will be met with a quick warning message by default. The Transfer Function measurement engines referencing Smaart Loopback are not delay-compensated, so the resultant delay times will be the sum of the measurement loop’s processing, Propagation Delay and the delay of any audio buffers in use in the Smaart Loopback channel.

    While this warning may have a jarring appearance, it is simply there to notify you of this additional Latency and should not affect the outcome of your measurement. Depending on what you're measuring with Smaart Loopback, this additional latency should not affect your tuning decisions (although it can seem alarming without a heads-up).

If you are using Wave drivers on Windows, your interface's inputs are treated as a different device from its outputs.

As such, you will also need to enable "Multi-Device TF" in the Advanced Settings menu to use Smaart loopback. This menu can be accessed by either navigating to Options > Preferences > Advanced or by using the [Alt/Option] + [J] hotkey.

The delay added due to the difference in input and output drivers while using the Multi Device TF setting will compound with the additional delay added by Smaart Loopback. To avoid this, we recommend choosing ASIO drivers over Wave, if possible.

  1. In your measurement engine configuration channel dropdown, select the output channel under the Smaart Loopback header. All outputs you selected for use will show up as inputs under the corresponding device.

From there on, you can set up your measurement channels as usual and you're ready to measure!