The screen shot below shows a Real-Time mode window layout with all optional window components visible. You can move your mouse cursor over the screen shot to identify the basic components and click on any section to find out more about it.
.png?sv=2026-02-06&spr=https&st=2026-11-18T17%3A24%3A01Z&se=2026-11-18T17%3A36%3A01Z&sr=b&sp=r&sig=zQZZu3UwUDyllbnHqyExka7Sq1yDgg7hogsNpwnYKqs%3D)
Example of the Transfer Function view. Additional controls for features enabled through Advanced Preferences are not shown.
The Real-Time mode window layout consists of the following basic components:
The Tab Bar shows you the names of all the tabs configured in that window and provides the means to switch between them.
The Data Bar on the left side of the window shows you the captured trace files in your data library whose data type (Spectrum or transfer function) matches the current active graph selection in the graph area (see below). You can drag files from the data library into the graph area to display them.
The graph area and cursor readout in the center take up most of the space in the window. These are the only window components that cannot be hidden (aside from the menus and window decorations).
The mode controls on the top-right allow you to switch between Real-Time, Impulse Response, and SPL modes.
The Control Bar on the right side of the window includes the SPL Meter/Clock (optional), live measurement controls for the active graph, Signal generator and main display controls.
The Command Bar at the bottom of the window is a user-configurable button bar to which you can assign a wide range of functions.