Navigation Pane (IR Mode)

Prev Next

The small time-Domain display in the upper part of the IR mode graph area is used for navigation and is always visible. The on-graph in the upper-left corner of the navigation pane selects the graph type to be displayed in this area. The navigation pane is limited to time-domain graph types only (Lin, Log or ETC).

Right-clicking ([Ctrl] + click on Mac) and dragging across this panel selects a specific time range for display on the larger time-domain charts. The full IR time record remains visible in the navigation pane when zoomed in (unless you use the crop function). Clicking anywhere in the left margin of the plot clears the zoom range and returns any time-domain graphs in the main display pane(s) to the full IR time record.

The crop button in the lower-right corner of the navigation pane can crop a file for display purposes to show only the selected time range – a very useful feature when working with IR measurements with long noise tails. Cropping is non-destructive and can be undone – clicking the crop button again on a cropped measurement restores the full extent of the original time record – however if you save the IR to a file while cropped, the cropped version is written to file.

The small, arrow-shaped widget positioned in the lower-left corner of the navigation pane (circled in red in the screenshot to the right) is the Time 0 marker. When you record a dual-channel Impulse Response measurement in Smaart, this marker is automatically set to match the reference Signal delay time – if you are familiar with real-time Transfer Function measurement, this is analogous to the center point of the Live IR display. For single-channel measurements or file-based data, Time 0 is set to the beginning of the time record. Dragging the marker to the left or right moves the time-zero point for all time-domain graphs (Lin, Log or ETC) displayed in the main graph area.