IR Mode Timer Macro

Prev Next

The Timer Macro has been added to Impulse Response Mode, allowing for the automation of multiple measurement captures. Users of the Timer Macro in Real Time Mode will recognize most of the options, with the addition of “Averages”.

  • Count Down: Once the Timer is started, Smaart will wait the designated number of seconds before performing data capture.

  • Generator On: The generator begins to run when the Timer is started.

  • Delay: Smaart will calculate the measurement engine’s delay time when the Timer starts (and before data is captured).

  • Averages: The number of averages run before the data is captured.

  • Generator Off: The generator will stop running when the Timer completes measurement capture.

  • Repeat: The number of consecutive measurements Smaart will capture while the Timer is running.