Audio (Preferences)

Prev Next

The Audio page of the Preferences dialog contains global settings that apply to all input and output devices selected for use in Smaart.

I-O Device Settings

  • Sample Rate sets the audio sampling rate for all audio input and output devices selected for use in Smaart (see I-O Config for more information). When using multiple (physical or virtual) audio devices, this should be set to a sampling rate that is natively supported by all devices.

  • Buffer Size – This field sets the buffer size (in samples) requested for all audio input and output devices selected for use in Smaart's I-O Config dialog. The default setting of 2048 samples works well for most audio analysis applications where we care more about stability than throughput delay (Latency). You can set it to a larger number if you are experiencing frequent glitches in your audio streams or to a smaller number if you need less latency but should proceed with caution in the latter case. On Windows, some ASIO drivers may ignore buffer size requests from applications, in which case you would need to change the buffer size in the driver's own control panel or companion app.

Audio Driver (Windows Only)

An example of Wave and ASIO API "devices" associated with a single 8-channel audio input device with stereo S/PDif.

Selections in this Windows-only section can be used to declutter the I-O Config dialog’s device list or for general troubleshooting. Windows drivers for most multi-channel audio devices include both ASIO (a widely adopted Audio Streaming Input/Output API developed by Steinberg) and native Windows Wave API drivers.

The ASIO API supports multi-channel input and output devices by design. Because the Wave API can only accommodate two inputs per device (and only stereo or 5.1 output formats), it will typically group inputs and outputs into pairs and present them as multiple stereo devices. This can result in a very long list of “devices” for a single interface with multiple inputs and/or outputs. Smaart will, of course, present only devices and channels selected for use in Audio I-O as options but it can still be a chore just sorting out which devices you want to use.

A second, much less common problem is that not all Wave API and ASIO drivers for a device are necessarily well-written. In some rare cases, simply opening and closing a particular device’s Wave and ASIO drivers in rapid succession (as Smaart and most other audio applications do when looking for available audio devices) can cause a driver to crash. In some extreme cases, this can also cause Smaart to crash. In such a case, this feature can serve as a workaround; Deselecting either driver box will also prevent Smaart from polling for the unselected driver type on start-up. Just remember not to un-check both boxes or you will have no available audio devices at all!