--- title: "Real-Time Mode GUI" slug: "real-time-mode-gui-1" status: "new" updated: 2026-11-03T15:38:25Z published: 2026-11-03T15:38:25Z canonical: "doc360.rationalacoustics.com/real-time-mode-gui-1" --- > ## Documentation Index > Fetch the complete documentation index at: https://doc360.rationalacoustics.com/llms.txt > Use this file to discover all available pages before exploring further. # Real-Time Mode GUI The screen shot below shows a *Real-Time* mode window layout with all optional window components visible. You can move your mouse cursor over the screen shot to identify the basic components and click on any section to find out more about it. ![](https://cdn.document360.io/a725c8f7-3a1a-4c09-9518-5d15d09a2ae2/Images/Documentation/image(47).png?sv=2026-02-06&spr=https&st=2026-11-18T17%3A30%3A09Z&se=2026-11-18T18%3A30%3A09Z&sr=b&sp=r&sig=hzoqrcR89EIhhDHsC2OQL5l1%2FeHgWiuw1id3%2BRvXCe0%3D) *Example of the Transfer Function view. Additional controls for features enabled through Advanced Preferences are not shown.* The Real-Time mode window layout consists of the following basic components: - The [*Tab Bar*](/v1/docs/tab-bar) shows you the names of all the tabs configured in that window and provides the means to switch between them. - The [Data Bar](/v1/docs/the-data-bar) on the left side of the window shows you the captured trace files in your data library whose data type (Spectrum or transfer function) matches the current active graph selection in the graph area (see below). You can drag files from the data library into the graph area to display them. - The [graph area](/v1/docs/real-time-mode-graph-area) and [cursor readout](/v1/docs/cursor-readout) in the center take up most of the space in the window. These are the only window components that cannot be hidden (aside from the menus and window decorations). - The mode controls on the top-right allow you to switch between Real-Time, Impulse Response, and SPL modes. - The [*Control Bar*](/v1/docs/real-time-mode-control-bar) on the right side of the window includes the *SPL Meter/Clock* (optional), live measurement controls for the active graph, Signal generator and main display controls. - The [*Command Bar*](/v1/docs/command-bar-config) at the bottom of the window is a user-configurable button bar to which you can assign a wide range of functions. The frequency (magnitude and phase) response of a system, function or network. The transfer function of the linear time invariant (LTI) system can be measured directly, using techniques such as dual-FFT transfer function measurements that compare the output of the system to its input signal in the frequency domain, or by taking the Fourier transform of the system’s impulse response. The frequency content of a given signal. The signal that describes the response of a system to an ideal impulsive stimulus in the time domain. The impulse response of linear time invariant (LTI) system is the inverse Fourier transform of its frequency-domain transfer function. Strictly speaking a signal can be any set of values that depends on some other set of values. In signal processing, the independent variable, e.g., time or frequency, is said to be the domain of the signal. In audio and acoustics, the things we most commonly think of as signals are time domain signals, where voltages or numeric values representing amplitude (the dependent variable) vary over time (the independent variable). But by strict definition, most of the things we see in Smaart could also be called signals, including transfer function Magnitude and Phase and RTA displays where relative energy or phase shift are presented as a function of frequency, rather than time.