Plot Calibrated Level is a setting that can be made active in the Spectrum page of the Graph Settings dialog. This menu is accessible by selecting Options > Graph Settings > Spectrum, using the [Alt/Option] + [S] hot key, or by clicking the settings button (
) in the lower-right corner of any Spectrograph or RTA graph in any main window graph area.
.png?sv=2026-02-06&spr=https&st=2026-11-18T17%3A29%3A57Z&se=2026-11-18T17%3A41%3A57Z&sr=b&sp=r&sig=qW0SOWQlDudtVfi3l14m9VC8BRvcfkMKD9llZ7Uo4is%3D)
Plot Calibrated Level setting in Spectrum Graph Settings.
When enabled via checkbox, Plot Calibrated Level applies input calibration offset (e.g., for SPL calibration) to RTA measurements (if applicable) and changes the default RTA display range to 20 dB to 120 dB. Note that this will result in a drastic difference in scale between data from inputs calibrated to SPL and inputs calibrated to digital Full Scale. When this option is not selected, Smaart ignores input sensitivity calibration and references all spectrum measurements to digital Full Scale. The default Magnitude range for RTA displays in that case is 0 to −100 dB.
By default, the y axis of the RTA plot displays level using dB Full Scale. However, since Spectrum target curves are set to specific sets of frequencies, this can mean that they sit incredibly high above any displayed data. When Plot Calibrated Level is enabled, however, any data from a calibrated input will be displayed within usable range of any target curve (assuming that the SUT is set to a suitable level for measurement).
in the top-right corner of the plot. As the logging continues, you will see a separate trace for the level of each octave band. To view the plot of a particular band, you can either cycle to it in the top plot or bring it to the front of the Z-order in the top-right drop-down menu.